Hatchrite Large Incubation Kit

Hatchrite Large Incubation Kit

No mixing! Just pour into the container it comes up, set up your eggs in the same container, set inside your incubator and you are set to go! Complete incubation kits for your reptile eggs!

1) Open kit and remove contents.

2) Open pre-measured bag of HatchRite™ and pour it into the incubation container. a. HatchRite™ material should clump together slightly and should fill container to approximately 75%.

3) Place eggs into incubation container. Nestle them about halfway into the HatchRite™. Place them in the position in which you found them. It is not recommended to rotate reptile eggs while they are incubating as it can cause death of the embryo.

4) Place the lid on the egg container. Be certain that your eggs do not come in contact with the lid on your container. Water condensation during the incubation process will collect on the lid and could be absorbed by the eggs if they come into contact with the lid. Note that your eggs will also swell as they develop and this too could cause them to come into contact with the lid. You should keep your eggs away from the sides of the chamber as well for the same reason.

5) Monitor your eggs. Open and inspect the egg container box once a week. This will allow for air exchange and give you an opportunity to check on the condition and health of the eggs. Dead or infertile eggs will typically discolor and begin to mold over in time. Live eggs generally retard mold growth. Molding eggs are best removed unless they are attached in the middle of a mass of connected eggs. In a connected group of eggs bad eggs should be left as not to risk damaging the other eggs.

6) Your eggs should remain full and robust throughout most of their incubation. It is not uncommon for some types of reptile eggs to sink in just prior (up to seven days before) to hatching. This is normal in some species. If your eggs start sinking in prior to 14 days before your projected hatch date it is typically a sign of dehydration. If this occurs simply open your egg incubation container and add a small amount of water into the corner of the container. The water will redistribute itself throughout the HatchRite™ medium. Be careful not to add too much water as this can drown the eggs. It is recommended to add small amounts over time to bring the moisture level back up rather than a large amount at one time. Do not spray or pour water directly onto the eggs.

7) Congratulations! On hatch day, remove your new babies from the egg container and consult one of the many good books that are available on care and maintenance of reptiles. ECO’s Professional Breeders Series are the most up-to-date care books available today and all are written by the people who breed, maintain, and specialize in the reptiles they write about.

8) Discard the HatchRite™. When eggs hatch they release leftover fluids into the HatchRite™ that will attract flies and will cause mold and bacteria to grow in the HatchRite™. For the best results, always use fresh HatchRite™ for each clutch.

Order
Hatchrite Large Incubation Kit